Centrotherm InnoFlue® ICEL2487 Concentric Elbow, 2/3 in, 87 deg, Aluminum/EPDM/Polypropylene

Centrotherm InnoFlue® Concentric Elbow, 2/3 in, 87 deg Angle, Aluminum/EPDM/Polypropylene, 4.4 in OD x 4.8 in L

• Incorporates flue exhaust and air intake into a single product requires less space and less wall/roof penetrations
• Accepted and approved by over 50 North American manufacturers of boilers, water heaters and furnaces
• Suitable for natural gas, propane and fuel oil condensing and non-condensing (flue temperature below 248 deg F) appliances
• Requires no primer/glue and does not leach chloride like PVC and CPVC
• Costs less and is faster and easier to install than stainless steel venting, no special tools needed, zero clearance to combustibles
• May be installed through a wall, inside a masonry chimney, sheetrock chase or between floor joists
• Lightweight, requires minimal support
• For offsets or changes in the direction of the vent systems
• Made in USA

Specifications